MIL-DTL-85670D
4.7 Test procedures. The right is reserved by the acquiring activity or the Government representative to modify the
tests or to require any additional tests deemed necessary to determine compliance with the requirements of the
specification or of the contract. MIL-T-18303 shall be used as a guide for preparation of test procedures. When
approved test procedures are available from a previous contract, such procedures will be provided and may be used
when their use is authorized by the acquiring activity.
4.8 Presubmission testing. No item, part, or complete equipment shall be submitted by the contractor until it has
been previously tested by the contractor and found to comply with all applicable requirements of this specification and
the contract.
5. PACKAGING
5.1 Packaging. For acquisition purposes, the packaging requirements shall be as specified in the contract or order
(see 6.2). When packaging of materiel is to be performed by DoD or in-house contractor personnel, these personnel
need to contact the responsible packaging activity to ascertain packaging requirements. Packaging requirements are
maintained by the Inventory Control Point's packaging activities within the Military Service or Defense Agency, or
within the military service's system commands. Packaging data retrieval is available from the managing Military
Department's or Defense Agency's automated packaging files, CD-ROM products, or by contacting the responsible
packaging activity.
6. NOTES
(This section contains information of a general or explanatory nature that may be helpful, but is not mandatory.)
6.1 Intended use. The antenna covered by this specification is intended for use with the AN/ARC-182(V) radio set
described by MIL-R-85664 and NAC Drawing Number 1533AS102. The antenna is also intended to operate with
equipment listed in 6.4. The antenna is intended to be newly installed or provide replacement for existing antenna on
the fuselage of an aircraft. They are intended for production incorporation in all new aircraft plus retrofit in selected
existing aircraft.
6.2 Acquisition requirements. Acquisition documents must specify the following:
a.
Title, number, and date of the specification.
If required, the specific issue of individual documents referenced (see 2.2).
b.
c.
Packaging requirements (see 5.1).
Marking (see 3.4.8).
d.
6.3 Qualification. With respect to products requiring qualification, awards will be made only for products which are,
at the time of award of contract, qualified for inclusion in Qualified Products List QPL No. 85670 whether or not such
products have actually been so listed by that date. The attention of the contractors is called to these requirements,
and manufacturers are urged to arrange to have the products that they propose to offer to the Federal Government
tested for qualification in order that they may be eligible to be awarded contracts or orders for the products covered
by this specification. Information pertaining to qualification of products may be obtained from DLA Land and
Maritime, Code VQE, P.O. Box 3990, Columbus, OH 43218-3990 or online at vqe.chief@dla.mil. An online listing of
products qualified to this specification may be found in the Qualified Products Database (QPD) at
6.4 Associated equipment. This equipment should operate with the associated equipment listed in table VII which
should not be supplied as part of this equipment:
21
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business